idler wheel rubber tyre replacement

Preparation

Required tools: Precision wire cutter, Security ring pliers for outer rings


Before you start to replace the old rubber wheel you have to remove the rubber mat and the platter. There is a circlip that prevents the platter to be removed. Be careful when you remove this circlip as the rubber mat is very sensitive and might be damaged if you use too much force.


Don’t forget: The circlip goes on the top off the rubber mat and you have to re-install it at the end of the procedure again. Without this circlip the auto stop will not functioning properly! 


Now you can lift up the platter from the axle.

Security ring pliers for outer rings

Precision wire cutter

Careful remove the circlip

Lift up the platter and remove it

© Copyright 2016 - 2024 – Urheberrechtshinweis

Alle Inhalte dieser Website, insbesondere Texte, Fotografien und Grafiken, sind urheberrechtlich geschützt. Das Urheberrecht liegt, soweit nicht ausdrücklich anders gekennzeichnet, bei Max Aeschlimann. Bitte fragen Sie mich, falls Sie die Inhalte dieser Website verwenden möchten.


All contents of this website, in particular texts, photographs and graphics, are protected by copyright. Unless expressly indicated otherwise, the copyright lies with Max Aeschlimann. Please ask me if you would like to use the contents of this website.

© 2016 - 2024 RESUS.CH ALL RIGHTS RESERVED

Last Update: 13.10.2023